The Hp Smartarray P800 Raid Controller (Hp D2D41 12 G1 Only); Overview; Part Numbers; P800 Controller Failure - HP D2D Service And Maintenance Manual

8 The HP SmartArray P800 RAID controller (HP D2D41 12
G1 only)

Overview

The HP StorageWorks D2D41 12 G1 Backup System uses the HP SmartArray P800 RAID controller
fitted with 512 MB RAM and two BBWCs (battery backed write cache).
IMPORTANT:
SmartArray P400 RAID controller and have one RAID battery. They are described in
SmartArray P400 RAID
Figure 37 HP D2D41 12 G1, location of the P800 controller
1 RAID controller
2 optional Tape Attach SAS or SCSI card
3 Fibre Channel card
WARNING!
information and user documentation provided with the server and P800 controller before attempting
the installation.

Part numbers

The replacement kit has a part number of 381513–B21. The component parts have the following
part numbers:
P800 card: 398647-001
512 MB memory: 398645–001
BBWC: 398648–001

P800 controller failure

Identifying a P800 card failure

P800 card failures are likely to occur only during power down or power up. Failure means that
the P800 card is unable to mount the RAID array. Status messages on the Web Management
Interface will advise that:
Summary page: RAID catastrophically failed
Storage page, RAID tab: RAID device is not available
40

The HP SmartArray P800 RAID controller (HP D2D41 12 G1 only)

The HP D2D4004, 4009 and 2500 Series G1 Backup Systems use the HP
Controller.
To reduce the risk of personal injury or damage to the equipment, consult the safety
The HP