After Replacing The Motherboard; G2 Products - HP D2D Service And Maintenance Manual

Table 3 J27 jumper settings
D2D Backup System
HP D2D4106/41 12 G2:
Remove all jumpers
HP D2D2502/2504 G2:
Jumper should be set on pins 1 and 2

After replacing the motherboard

G2 products

For all G2 products you must:
1. Install the latest BIOS revision from the relevant product site. All BIOS revisions can be found
at http://www.hp.com/support/downloads
to disk Backup — HP D2D Backup Systems).
2. Reboot the system. During the system BIOS boot process, when the prompt to Press F9 is
visible, press the F9 key to enter the RBSU (ROM-based Setup Utility) or BIOS Setup. This is
so that you can change.
3. Change the Performance options, as shown in the following table.
NOTE:
Table 4 RBSU settings
RBSU setting
Advanced Options
Advanced Options
(HP D2D4324/4312
only)
Power Management
Options
4. Change the BIOS ID, as shown in the following table.
Table 5 BIOS IDs for G2 products
Model
D2D2502i G2
Unless noted otherwise, the settings apply to all G2 products.
Sub-setting
Advanced
Performance Tuning
Options
Service Options
Thermal Configuration
HP Power Profile
HP Power Regulator
(under Storage — Disk Storage Systems — Disk
Sub-sub-setting Current
Memory Speed with 1066 MHz
2 DIMMs per Maximum
Channel
Product Id (ignore M/B default
warning displayed)
Optimal Cooling
Balanced Power and
Performance
HP Dynamic Power
Savings Mode
BIOS ID number
596141-B21
Change to...
1333 MHz Maximum
Appropriate Product
ID for G2 shown in
table below
Increased Cooling
Maximum
Performance
HP Static High
Performance Mode
After replacing the motherboard 21