Epson DFX 8500 Service Manual page 99

DFX-8500
0 Confim, that the cables are connected correctly (Refer to Figure 3- 12.)
0 Tighten the screws while pulling the printhead as shown below to secure the printhead firm/y
Figure 314. Printhead Installation
Step 12: install the heed cable cover and the connector cover.
Step 13: Wipe off any stains from the carriage guide shaft, lubricate both ends of the carriage guide shaft
with the included oil (O-2). and spread the oil over the shaft by moving the carriage manually.
Figure 3-15. Lubricating to Carriage Guide Shafts
0 When you install the printbead, perform the platen gap motor value (platen gap) a+stment
desctib6dinSection4.1.7).
3-12
Rev. A