Ribbon Feed Change Lever Unit Removal - Epson DFX 8500 Service Manual

3.2.6.2 Ribbon Feed Change Lever Unit Removal
Step 1:
Release
the three hooks securing the ribbon feed gear cover to the ribbon feed motor frame and
remove the cover and the ribbon feed gear.
Step 2: Disconnect the three connectors from the connector junction board, as shown in Figure 3-46.
Step 3: Remove the head damper from the left side frame.
Step 4: Remove the fan on the left frame. (Refer to Section 3.2.6.1,)
Ribbon Feed
Change Lever Unit
Ribbon Feed Gear Cover
kbbon Feed
Gear
Ribbon Feed
Motor
Ribbon Feed
Motor Frame
_
Figure 3-46. Ribbon Feed Change Lever Unii Removal (l/Z)
Step 5:
Remove
the two CBS (M3x6) screw securing the ribbon feed change lever unit to the left side frame,
then remove the ribbon feed change lever unit.
Connector
for /
Ribbon Feed motor
Connector for
Tractor Select Sensor
\ Ribbon Feed Change
Lever Unit
Figure 3-47. Ribbon Feed Change Lever Unit Removal (Z/Z)
3-32
Rev. A