Epson DFX 8500 Service Manual page 117

DFX-8500
Step 5: Remove the four screws securing the printer mechanism to the lower case
Screws
Screws
Figure 343. Printer Mechanism Removal l/Z
Step 6: Install the lift handles from the inside of the printer mechanism. Insert each handle through the
two holes in the side frames of the printer mechanism. Then slowly lit up the printer mechanism
using the handles and remove it from the lower case.
Lii Handle #E&S6
nter Mechanism
Lower Housing Assembly
Figure 3-44. Printer Mechanism Removal CC/Z
When you install the pdnter mechanism, KU? the cables as shown in Figures
3-4 I
and 3-42. Make sure
ths cables do not ga? caught between the printer mechanism and lower case.
When you install the printer mechanism, pefiom~ the following a@ustments:
0 Platen gap motor value (platen gap) a&stment (described in Section 4.1.7)
0 Bidireciionaiprinting adjustment (desctibed in Section 4.1.8)
,
3-30
Rev.
A