Panasonic PT-EX12KU Operating Instructions Manual page 27

6) Select the light-shielding plate to be
attached.
zLight-shielding plate for each lens
Refer to the following table and use an appropriate
light-shielding plate.
Accessory (product name)
Light-shielding plate-1
(T0CRS0008--1)
Light-shielding plate-2
(T0CRM0014--1)
is inscribed
Light-shielding plate-3
(T0CRM0013--1)
is inscribed
*1: Use the light-shielding plate-1 and light-shielding plate-3
together.
Attention
■
z The light-shielding plate-2 and light-shielding
plate-3 should be separated to the upper and lower
plates.
■
z Make sure that the shape of the light-shielding plate
matches the lens.
■
z Make sure that the attaching direction of the light-
shielding plate is correct and set them properly.
7) Insert the lower light-shielding plate.
Lens Model No.
ET-ELW03
*1
ET-ELW04,
ET-ELW06,
ET-ELS02,
ET-ELS03,
ET-ELT03
ET-ELW02,
ET-ELW03 *1 ,
ET-ELT02,
ET-ELM01
Upper plate
Lower plate
Attaching the lens
8) Attach the lens into the projector body.
(i) Hold the lens lock lever and slide it upward to
release the lock, and then insert the lens with
the lens attachment into the projector body.
(ii) Hold the lens lock lever and slide it downward
until the lever clicks to secure the lens.
•■When attaching the motor driven lens, be
sure to move the motor to the right side to
attach the lens.
•■After attaching the lens, make sure that the
lens is not loose and is properly attached.
9) Adjust the focus of the projection lens
(ET-ELW03 only).
■
z For details, refer to "Adjusting the focus"
( page 30).

■
z If the focus adjustment is not necessary, go to
Step 10).
ENGLISH - 27