Craftsman 320.19730 Operator's Manual page 12

_-_!'!: _" _' I
I
10. To change the width of the Table
Top Assembly working area,
turn the TableTop Assemb/y's
two Clamp Knobs (I) clockwise
to unlock them ss shown
Ftgo 11
Close up view of Table Top
Assembly's clamp knob.,
12 After loosening the Table Top
Assembly's Clamp Knobs,
adjust the Table Top Assembly
to the desired position to mount
your power tool
Fig 13 :;=_iii_
I
13 Be sure that after adjusting the
wldth of the Tabfe Top Assembly,
you lock the two Clamping Knobs.
Th_s is done by turning them
until securely tightened.
12