Advertisement
Available languages
Available languages
FENCE
Figure 24
HOLDDOWN
Figure 25
E
c
///
ii
/
I/i
B
D
C
The Fence can be moved in and out to accommodate
various size workpieces.
1.
To move Fence, loosen Lock Knob (A) See Figure 24.
2.
Loosen Fence Lock Handle (C) until the Fence
Glide Shaft (B) can slide freely.
3.
Slide Fence in or out to the desired location.
4.
Tighten Fence Lock Handle to lock the fence in place.
The purpose of the holddown is to prevent the work-
piece from lifting as the chisel is raised up.
1.
To adjust, loosen set screw (A). See Figure 25.
2.
Position Holddown (B) until it just touches the top of
the workpiece (C) and allows the workpiece to slide
left or right.
NOTE: The holddown can be turned upside down to
accommodate thicker workpieces.
3. Once Holddown is in position, retighten set screw.
MICRO ADJUST
ASSEMBLY
Sometimes it is necessary to move the fence in small
increments. When this is the case, the Micro Adjust
Assembly should be used.
1.
Make sure that the Lock Knob (A) is tightened
down on the Fence Glide Shaft (B). See Figure 24.
2.
Loosen the Fence Lock Handle (C) so that the
Fence (D) may slide smoothly.
,
Rotate the Adjustment Knob (E) clockwise to move
the fence in towards the mortiser column.
Rotate
counterclockwise
to move the fence away from the
mortiser column.
17
Advertisement
