Tool And Chisel Holder - Craftsman 351.219071 Instruction Manual

TOOL AND CHISEL HOLDER
Make sure that the machine is disconnected from the
power source.
Figure 13
®
C
/
,
,
,
Insert the support bar (A) into the support bracket
(B). See Figure 13.
Place the support bar through the hole (C) of the
tool and chisel holder.
Use tool and chisel holder to store all chisels and
chuck keys when not in use.
FASTENING MACHINE TO
SUPPORTING SURFACE
Figure 14
If during operation there is any tendency for the morfiser
to tip over, slide, or walk on the supporting surface, the
base must be secured to the supporting surface with
fasteners (not supplied), through the two holes (A)
located in the mortiser base.
13