Advertisement
Available languages
Available languages
Figure 7
Figure 9
,
,
8.
,
Detach Hydraulic Cylinder (E) from lower junction
screw See Figure 7.
Unscrew lower junction screw (F).
Insert final M8 x 30mm hex head screw (G) through
the bottom of the mortiser, thread into the base,
and tighten securely.
Screw in lower junction screw and reattach the
hydraulic cylinder as explained in HYDRAULIC
CYLINDER ASSEMBLY.
FENCE ASSEMBLY
Make sure that the machine is disconnected from the
power source
Figure
8
,
,
\
©
E
/
F
Insert Guide Rod (A) through hole in Hold Down (B)
and tighten set screw (C) using supplied 4mm T
Handle allen wrench.
See Figure 8.
Insert Guide Rod into hole (D) of Fence Assembly
(E) and tighten set screw (F) using supplied 4mm
T Handle allen wrench.
11
G
3.
Insert fence glide shaft (G) through hole (H) in
column of the mortiser. See Figure 9.
Figure 10
4.
Thread Short Fence Lock Handle (I) into the
column of the mortiser. Tighten to secure fence.
See Figure 10.
NOTE: Fence Lock Handle is spring loaded and can be
repositioned by pulling out on the handle and rotating it.
Advertisement
