Dell 3110 Color Laser User Manual page 153

Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings
for the wireless network. The change becomes effective after the printer is turned off and then on again.
Values:
Used when auto-detecting the PostScript communication protocol.
Auto*
Used when the communication protocol is in ASCII interface.
Standard
Used when the communication protocol is in binary format.
BCP
Used when the communication protocol supports both ASCII and binary data to switch between
TBCP
them according to the specified control code.
Used when no special processing is required.
Binary
Parallel
The Parallel menu can be adjusted to configure the parallel interface.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
ECP
Purpose:
To specify the ECP communication mode of the parallel interface. The change becomes effective after the
printer is turned off and then on again.
Values:
The ECP communication mode is enabled.
Enable*
The ECP communication mode is disabled.
Disable
Adobe Protocol