Table of Contents
Advertisement
Installation
After setting a network address for all the players and
registering the players with the VSPA-D7 software, install
each player in its actual operating location and connect
them as shown in the figure below.
Notes
• Connect a display device to the
player with an RGB cable. If a player is not connected to
a display device, it cannot start operation.
• The figure above shows an example of controlling the
display device using an RS-232C connection. A display
device can be controlled from a player via a network,
depending on the model of the display device.
In such a case, the connection between the
connector and the RS-232C connector of the display
device is not required. Instead, connect the display
device to the network.
Network (Internet/intranet)
VSP-NS7
Digital Signage Player
1
RS-232C
Analog RGB
connector
connector
Speaker
Display device
connector of each
1
For details such as how to install rubber feet on a player
and how to install a player onto the back of a professional
display device, refer to the player's Operating
Instructions.
Computer
(Running the VSPA-D7
Management Software)
Speaker
• Be sure to use the upper
for the player that you want to connect to the display
device.
This
1 connector is a dedicated connector for
controlling display devices in this system. Be careful
that if a non-supported device is connected to it and data
is sent to the connector, it may result in a malfunction.
1 as the serial connector
Installation
11
Advertisement
Table of Contents
