D-Link DCS-2102 - SECURICAM Network Camera User Manual page 36

Scheduling
Event Based: Event based recording will allow you to record video when specific events
happen.
Motion detection triggered recording:
record video when motion is detected by the camera.
Digital input triggered recording: When the camera receives a signal from its DI
input, it will start recording. You can find more information about the DI/DO interface
at the end of this document.
Prerecord: This will set how many seconds of video before the event takes place
will be recorded.
Postrecord: This will set how many seconds of video after the event takes place
will be recorded.
Example: Using motion detection triggered recording and setting Prerecord to 5
seconds and Postrecord to 9 seconds, the camera will save video from 5 seconds
before motion was detected to 9 seconds after motion was detected.
Continuous: This will set the camera to record continuously. This scheduling method can
only be done when recording to a Samba drive.
Scheduled Recording: This will set the camera to automatically record video during the
specified times in the table below. This scheduling method can only be done when
recording to a Samba drive.
After making any changes, click the Save Settings button to save your changes, or click the
Don't Save Settings button to discard your changes.
Enabling this option will set the camera to
33