Restoring Factory Default Settings - Hitachi L200 Series Instruction Manual

6–8

Restoring Factory Default Settings

Restoring Factory Default Settings
You can restore all inverter parameters to the original factory (default) settings for the
intended country of use. After initializing the inverter, use the powerup test in Chapter 2
to get the motor running again. To initialize the inverter, follow the steps below.
No.
1
Use the
navigate to the "B" Group.
2
Press the
3
Press and hold the
4
Press the
5 Confirm the country code is correct. Do not change it unless you are absolutely sure the
power input voltage range and frequency match the country code setting.
To change the country code, press
6
Press the
7
Press the
8
Press the
9
Press the
10
Press the
11
Press and hold the
and
12 When your country code appears in
the display, release all the keys.
13 Initialization is complete.
NOTE: Initialization cannot be performed with a remote operator panel. Disconnect the
device and use the inverter's front panel keypad.
Action
FUNC. 2
, , and keys to
1
FUNC.
key.
key until ->
1
FUNC.
key.
FUNC. key.
2 key.
key.
FUNC.
key.
1
STR
key.
,
FUNC. ,
1
STOP
keys. Do not release yet.
RESET
Display
"B" Group selected
b
– – –
First "B" parameter selected
b
0 0 1
Country code for initialization
b
0 8 5
selected
00 = Japan, 01 = Europe,
0 2
02 = USA
or
2 STR
to set,
1
Country code for initialization
b
0 8 5
selected
Initialization function selected
b
0 8 4
00 = initialization disabled,
0 0
clear trip history only
01 = initialization enabled
0 1
Initialization now enabled to
b
0 8 4
restore all defaults
First part of special key
, b
2 0 8 4
sequence
Default parameter country code
E U
shown during initialization
process (left-most char displays
U S A
alternating pattern)
Function code for output
d
0 0 1
frequency monitor shown
Func./Parameter
to store.