Update" Items; Mechanism Adjustment - Epson Stylus Pro 9000 Service Manual

EPSON Stylus Pro 9000

"UPDATE" ITEMS

The items you can update are described below.
The parameters will update and be stored in the Flash
memory on the Main Board the next time the printer is
turned off.
o Capping Position
o
Head Rank
o
Print Position Items (Bi-D Adjustment/Gap Adjustment)
o Paper Feed Distance
o
Mechanism Adjustments
o Ink Parameters
You can reset the Initial Ink Charge flag, causing the printer to perform the
initial ink charge the next time the printer is turned on.
Update: Ink Parameter
Paper Feed [+]/[-]
Update Parameter?
Enter
Updating Parameter
Adjustment
Init Ink Charge Flag: SET
Init Ink Charge Flag: RESET

5.2.8 Mechanism Adjustment

This section describes the mechanism adjustments you need to perform when
replacing or removing certain parts. The parts and their corresponding
adjustments are as follows.
Table 5-13. Necessary Mechanism Adjustments
Parts
o
Printhead
Carriage cover height CR Cover Position Adjustment
o
Ink
Damper
Assembly
o
Cutter
solenoid
o
Carriage
cover
CR Motor CR Steel Belt
PF Motor PF Belt Tension
PG Motor Gear Backlash
Lower Paper Cutter Position
Guide
I/H Assembly I/H Handle Gear
position match
P THICK Self-diagnostic test -
sensor "Paper Thickness"
Cover Open Self diagnostic test -
R/L sensor
Adjustment Steps
Adjustment Necessary Tools
Tool #F724
code: 1049975
Tension Gauge #F712
Tension code: 1047744
Standard: 200g
Tension Gauge
code: B747700300
Standard: 4000g
confirm by sight
confirm by sight or by
measuring with a ruler
confirm by sight
-
-
"Cover"
Revision B
Refer to
page 139
page 141
page 141
page 142
page 140
page 142
page 143
page 144
138