Monitor Controls, Connectors, And Indicators - HP Model 712/100 - Workstation Handbook

Monitor Controls, Connectors, and Indicators

This section describes the controls, connectors, and indicators for the supported mon-
itors.
The Power–On LED, when lit, indicates that the monitor has ac power applied. Use
the following controls to adjust the monitor:
The Power–On button turns the monitor's power on and off.
The Brightness control adjusts the brightness of the display.
The Contrast control adjusts the light–to–dark and dark–to–light contrast of the
display.
The Degauss control demagnetizes the color monitor. Degaussing disperses any
accumulated magnetic charge from the face of the monitor. Magnetic distur-
bances such as picture distortion or color impurity can be caused by either
moving the monitor from one place to another or swiveling the monitor on its
base.
Refer to the manual that came with the monitor for information on any other controls
that may be present on the monitor.
The following figures illustrate the monitors for the workstation.
Figure 1–3 shows the 12–inch, 1024x768, flat panel display.
NOTICE: The 12–inch, 1024x768, flat panel display is not sup-
ported on the Model 712/100.
Figure 1–4 shows the 15–inch, 1024x768, color monitor.
NOTICE: The 15–inch, 1024x768, color monitor is not sup-
ported on the Model 712/100.
Figure 1–5 shows the 17–inch, 1024x768, color monitor.
Figure 1–6 shows the 19–inch, 1280x1024, color monitor.
1–8 Product Information