Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZWJ 12591 W
Summary of Contents for Zanussi ZWJ 12591 W
- Page 1 User manual Washing Machine ZWJ 12591 W ZWJ 14591 W...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 14 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4... -
Page 3: Product Description
• If the machine is situated on a carpeted floor, please aged so that the inside of the washing machine is ac- adjust the feet in order to allow air to circulate freely cessible. under the appliance. Child safety • Always be sure, that there is no water leakage from ho- •... -
Page 4: Control Panel
Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. -
Page 5: Table Of Symbols
Programme selector dial EXTRA RINSE button SPIN reduction button ECONOMY button SOIL LEVEL button: Display START/PAUSE button – Heavy DOOR LOCKED pilot light – Light DELAY START button PREWASH button Table of symbols = Rinse hold = Child Safety Lock Programme selector dial, spin speed button and available options Programme Selector Dial •... - Page 6 Extra Rinse Delay Start This appliance is designed to save energy. If it necessary The programme can be delayed from 30 min - 60 min - 90 to rinse the laundry using an extra quantity of water (extra min, 2 hours and then by 1 hour up to a maximum of 20 rinse), select this option.
-
Page 7: Washing Programmes
Delayed start The delay set appears for a few seconds, then the display show again the duration of the set programme. The delay time value decreases by one unit every hour and then, when 1 hour remains, every minute. Alarm codes In the event of operating problems, some alarm codes can be displayed, for example (see paragraph «What to do if...»). - Page 8 Programme Maximum and Minimum Temperature Detergent Cycle Description Options Compartment Maximum Spin Speed Type of Laundry Cycle time duration, energy and water consumption are proportional to the amount of load. 1) If you select the ‘LIGHT’ option (button 3), we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results.
- Page 9 Programme Maximum and Minimum Temperature Cycle Description Detergent Options Maximum Spin Speed Compartment Maximum Fabrics Load Type of Laundry Wool - Hand wash SPIN REDUCTION 40° - 30° - Cold RINSE HOLD Main wash - Rinses Maximum spin speed at 900 rpm Max.
-
Page 10: Helpful Hints And Tips
Programme Maximum and Minimum Temperature Cycle Description Detergent Options Maximum Spin Speed Compartment Maximum Fabrics Load Type of Laundry = OFF For cancelling the programme which is running or to switch the machine off . Helpful hints and tips Sorting out the laundry Mould stains: treat with bleach, rinse well (whites and fast coloureds only). -
Page 11: First Use
• liquid detergents, preferably for low temperature wash Follow the product manufacturers’ instructions on quanti- programmes (60°C max) for all types of fabric, or spe- ties to use. cial for woollens only. Use less detergent if: The detergent and any additives must be placed in the ap- •... -
Page 12: Daily Use
Daily use Load the laundry Turn the selector dial to position to reset the pro- gramme/to switch the machine OFF. Open the door by carefully At the end of the programme the selector dial must be pulling the door handle turned to position , to switch the machine off. - Page 13 Select the Delay Start by pressing button 8 Interrupting a programme Before you start the programme, if you wish to delay the Press the button 7 to interrupt a programme which is run- start, press this button to select the desired delay. ning, the corresponding pilot light starts blinking.
-
Page 14: Care And Cleaning
Stand by : once the programme has finished after a few ton the appliance will come out of the energy saving sta- minutes the energy saving system will be enabled. The tus. brightness of the display is reduced. By pressing any but- Care and cleaning Cleaning the drawer recess Warning! You must DISCONNECT the appliance... - Page 15 Open the pump door. Put a container below the recess of the drain pump to collect the water that flows out. Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. Press the two levers and pull forward the drainage duct to let the water flow out.
- Page 16 Cleaning the water inlet filters • Screw the hose back to the machine and make sure Important! If the appliance doesn't fill, takes long to fill the connection is tight. with water, the starting button blinks yellow or the display •...
-
Page 17: What To Do If
Start the programme to drain the water. What to do if… Certain problems are due to lack of simple maintenance or • : problem with the water supply. oversights, which can be solved easily without calling out • : problem with the water draining. an engineer. - Page 18 Problem Possible cause/Solution The drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged. • Clean the drain filter. The machine does not empty and/or An option or a programme that ends with the water still in the tub or a that does not spin: eliminates all the spinning phases has been selected.
-
Page 19: Technical Data
Problem Possible cause/Solution The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance. The machine vibrates is noisy: The laundry is not evenly distributed in the drum. -
Page 20: Consumption Values
Water supply pressure Minimum 0,05 MPa Maximum 0,8 MPa Maximum Load Cotton 8 kg Spin Speed Maximum 1200 rpm (ZW J12591 W) 1400 rpm (ZWJ14591 W) Consumption values Programme Energy consumption (KWh) Water consumption (litre) White Cottons 95 °C Cottons 60 °C 1.65 Cottons 40 °C Synthetics 40 °C... - Page 21 Installation on suspended flooring Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a wa- terproof wood panel, at least 15 mm thick under the appli- ance, secured to at least 2 floor beams with screws, the wood panel must extend beyond the front feet.
- Page 22 The other end of the inlet hose which connects to the Place the drain hose into your standpipe, which should appliance can be turned as showed in the picture. have an internal diameter of approximately 38 mm thus Do not place the inlet hose downwards. Angle the hose ensuring there is an air break between the drain hose to the left or right depending on the position of your and standpipe.
-
Page 23: Environmental Concerns
Electrical connection If the outlet spigot has not Push the drain hose onto Any electrical work required to install this appliance been used before, remove the spigot and secure with should be carried out by a qualified electrician or compe- any blanking plug that a clip, ensure a loop is tent person. - Page 24 • Normally soiled laundry may be washed without pre- your local council, your household waste disposal service washing in order to save detergent, water and time (the or the shop where you purchased the product. environment is protected too!). Packaging materials •...
- Page 28 www.zanussi.com/shop...