Sensor Frame And Y-Cutter Arm L; Removing The Sensor Frame; Removing The Y-Cutter Arm L - Brother LX-200 Service Manual

3.8 Sensor Frame and Y-cutter Arm L

3.8.1

Removing the Sensor Frame

1. Position the chassis unit as shown in the diagram. Remove the paper sensor crank
from the paper feed roller.
2. Remove the two sensor frame screws.
3. Lift the right end of the sensor frame to release it from the top-right boss. Move the
sensor frame to the left to release it from the two bosses at the left. Remove the
sensor frame.
Chassis right side
Paper sensor crank
3.8.2

Removing the Y-cutter Arm L

Remove the two arm shaft rings and pull the Y-cutter arm shaft in the direction of the
arrow to remove the Y-cutter arm L.
Sensor frame screws
Fig. 3.8-1 Removing the Sensor Frame
Y-cutter arm L
Y-cutter arm L
Y-CA timing belt
Y-CA chassis screw
Fig. 3.8-2 Removing the Y-cutter Arm L
3-23
Chassis left side
Sensor frame