Baumatic BDF682SL Instruction Manual page 30

E4
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E6
o Open circuit
Thermistor
Call the Customer Care Department.
E7
o Short circuit
Thermistor
Call the Customer Care Department.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Switch the appliance back on using the ON/OFF button.
o Wait for a further 5 seconds before attempting to set a wash
program, using the program selection buttons.
IMPORTANT: If any other fault code appears in the
display window, you should not attempt to clear it yourself
and contact the Customer Care Department.
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
THE CUSTOMER CARE DEPARTMENT ON TELEPHONE
NUMBER (0118) 933 6911.
30