Default Ospf Configuration - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Configuring OSPF

Default OSPF Configuration

Table 35-5
Table 35-5
Feature
Interface parameters
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
NSF
NSF capability
Catalyst 3750 Switch Software Configuration Guide
35-26
shows the default OSPF configuration.
Default OSPF Configuration
1
awareness
Default Setting
Cost: No default cost predefined.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Priority: 1.
Hello interval: 10 seconds.
Dead interval: 4 times the hello interval.
No authentication.
No password specified.
MD5 authentication disabled.
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mbps.
Disabled. When enabled, the default metric setting is 10, and the
external route type default is Type 2.
Built-in, automatic metric translation, as appropriate for each
routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are
flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
2
Enabled . Allows Layer 3 switches to continue forwarding
packets from a neighboring NSF-capable router during hardware
or software changes.
Disabled. Beginning with Cisco IOS Release 12.2(35)SE, the
Catalyst 3750 switch supports OSPF NSF (NSF-capable
routing) is supported for IPv4.
Chapter 35 Configuring IP Unicast Routing
OL-8550-02