Installation Guide
N600 Wireless Dual Band Gigabit Router
Premium Edition
WNDR3800
Package Contents:
Ethernet cable
Slide-on
router stand
N600 Wireless Router
Power adapter
(with stand attached)
Attach the stand to the router:
1. Place the stand on a level surface.
2. Slide the router onto the stand.
Step 1:
Unplug the power
to turn off your modem.
DSL
or Cable
Internet
Modem
Step 4:
Connect the power adapter to the
router, then plug it into an outlet.
Wait for the 2.4 GHz LED (
)
2.4
GHz
to turn on.
If none of the LEDs turn on, make sure that
the Power On/Off button is in the ON position
(pushed in).
Step 2:
Connect one end of the yellow
Ethernet cable (
) to your modem,
and the other end to the Internet port
on your router.
Power On/Off
N600 Wireless Router
Step 5:
Connect the router
to your computer.
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Step 3:
Plug in, then turn on your modem.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
(not included)
Laptop or desktop
computer
Step 6:
Open a browser.
If the W eb page does not display,
close and re-open the browser
and enter
http://routerlogin.net
in
the address bar, or check the
"Troubleshooting" section on
the back of this installation guide.