Table of Contents
Advertisement
button. If the Control Center is in range, the Armed
light will begin flashing on the Control Center and
the Control Center will begin beeping for 45 seconds
indicating the alarm has been set.
Arming the Alarm in Home mode
Enter a 4-digit user code (See Programming Security
Codes into the Wireless Keypad) and press the Home
button. If the Control Center is in range, the Armed light
on the Control Center will light indicating the alarm has
been set.
Disarming the Alarm*
Enter a 4-digit user code (See Programming Security
Codes into the Wireless Keypad) and press the
Disarm button. If the Control Center is in range, the
Armed light on the control center will turn off, or if the
alarm is sounding, it will stop.
Using the Panic Button*
Pressing the red Panic Button at any time will cause
the siren to sound instantly. It is not necessary to enter
a 4-digit user code to activate the Panic button.
To stop the siren from sounding, you must disarm
the system (see Disarming the Alarm).
*Note: The Wireless Keypad will transmit up to 150ft
from the Control Center. When pressing the Panic
or Disarm buttons, there will be up to 3 seconds
delay before the Control Center can receive another
command. The Control Center must complete
transmitting activation signals (3 seconds) before it
can receive a new command.
12
Advertisement
Table of Contents
