Cisco 2431 - IAD Router Hardware Installation Manual page 29

Chapter 2 Switch Installation
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Warning The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device. Statement 1019
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Warning
Statement 1022
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
Warning This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. Statement 1045
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
122°F (50°C) Statement 1047
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
Warning No user-serviceable parts inside. Do not open. Statement 1073
OL-7678-01
Cisco ME 2400 Ethernet Access Switch Hardware Installation Guide
Preparing for Installation
2-3