Defining Classic Spanning Tree - HP BladeSystem bc2000 - Blade PC User Manual

Defining Classic Spanning Tree

The STP Properties page contains parameters for enabling STP on the device.
To enable STP on the device:
1. Click Layer 2 > Spanning Tree > Properties. The STP Properties page opens.
STP Properties
The STP Properties page contains the following fields:
❏
Spanning Tree State — Indicates whether STP is enabled on the device. The possible
field values are:
◆
Enable — Enables STP on the device.
◆
Disable — Disables STP on the device.
❏
STP Operation Mode — Specifies the STP mode that is enabled on the device. The
possible field values are:
◆
Classic STP — Enables Classic STP on the device. This is the default value.
◆
Rapid STP — Enables Rapid STP on the device.
◆
Multiple STP — Enables Multiple STP on the device.
❏
BPDU Handling — Determines how BPDU packets are managed when STP is disabled
on the port or device. BPDUs are used to transmit spanning tree information. The
possible field values are:
◆
Filtering — Filters BPDU packets when spanning tree is disabled on an interface.
This is the default value.
◆
Flooding — Floods BPDU packets when spanning tree is disabled on an interface.
❏
Path Cost Default Values — Specifies the method used to assign default path cost to
STP ports. The possible field values are:
Embedded Web System User Guide www.hp.com
Configuring Spanning Tree
9-3