Configuring Mgcp On The Cisco Vgd 1T3 Voice Gateway - Cisco VGD-1T3 Software Configuration Manual

Configuring MGCP Gateway Support
•
•

Configuring MGCP on the Cisco VGD 1T3 Voice Gateway

Perform this task to configure MGCP on the Cisco VGD 1T3 voice gateway to support Cisco Unified
Communications Manager.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface gigabitEthernet slot/port
Example:
Router(config)# interface gigabitEthernet 0/0
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
120
Configuring MGCP PRI Backhaul and T1 CAS Support for Cisco Unified Communications
Manager, page 139
Verifying the MGCP PRI Backhaul Configuration, page 142
enable
configure terminal
interface gigabitEthernet slot/port
ip address ip-address subnetmask
no shutdown
exit
hostname name
mgcp
mgcp call-agent {ip-address | host-name} [port] [service-type type] [version version-number]
mgcp dtmf-relay voip codec {all | low-bit-rate} mode {cisco | nse | out-of-band}
ccm-manager mgcp
exit
Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
Purpose
Enables privileged EXEC mode.
Enter your password when prompted.
•
Enters global configuration mode.
Enters interface configuration mode so that you can
configure the gigabitEthernet interface for
communicating with Cisco Unified Communications
Manager.
• slot and port syntax is platform-dependent; type ?
to determine.