Cisco Linksys WUSB600N User Manual page 21

Chapter3
Advanced Setup
If your network is not listed with the available networks,
use Advanced Setup.
Available Wireless Networks
1. Click Advanced Setup on the Available Wireless
Networks screen to set up the Adapter manually.
2. The Network Settings screen appears.
Wireless Network
If your network has a router or other DHCP server, select
Obtan network settngs automatcally (DHCP).
If your network does not have a DHCP server or router,
select Specfy network settngs. Enter an IP Address,
Subnet Mask, Default Gateway, and DNS addresses
appropriate for your network. You must specify the
IP Address and Subnet Mask on this screen. If you are
unsure about the Default Gateway and DNS addresses,
leave these fields blank.
IP Address This IP Address must be unique to
–
your network.
Subnet Mask
The Adapter's Subnet Mask must be
–
the same as your wired network's Subnet Mask.
Dual-Band Wreless-N USB Network Adapter
Advanced Configuration
Default Gateway Enter the IP address of your
–
network's Gateway.
DNS  and DNS 
Enter the DNS address of your
–
wired Ethernet network.
Click Next to continue, or click Back to return to the
previous screen.
3. The Wireless Mode screen shows a choice of two
wireless modes.
Wireless Mode
Infrastructure Mode
–
to connect to a wireless router or access point.
Ad-Hoc Mode
Select this mode if you want to
–
connect to another wireless device directly without
using a wireless router or access point.
Wreless Network Name
–
name (SSID) that must be used for all devices in
your wireless network. It is case-sensitive and
should be a unique name to help prevent others
from entering your network.
Click Next to continue, or click Back to return to the
previous screen.
Select this mode if you want
Enter a wireless network