Eth_Port_Channel Messages; Eth-Port-Sec-5 - Cisco AP775A - Nexus Converged Network Switch 5010 Reference

ETH_PORT_CHANNEL Messages

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - f e e d b a c k - d o c @ c i s c o . c o m
Error Message
secure port [chars] in Vlan [dec] has been removed
ETH_PORT_CHANNEL Messages
This section contains the ETH_PORT_CHANNEL messages.
ETH_PORT_CHANNEL-1
Error Message
[[chars]]
Error Message
Error Message
[chars] [[chars]]
Error Message
[chars]: [chars]
Cisco NX-OS System Messages Reference
2-158
ETH-PORT-SEC-5-ETH_PORT_SEC_HOST_DELETION: Host [chars] bound to
Explanation A host has been removed.
No action is required.
Recommended Action
ETH_PORT_CHANNEL-1-LC_CFG_FAILURE: configuring module [dec] failed
Module configuration failed.
Explanation
Module will be automatically reset.
Recommended Action
ETH_PORT_CHANNEL-1-MALLOC_FAILED: cannot allocate memory (size [dec])
Not enough memory.
Explanation
No action is required.
Recommended Action
ETH_PORT_CHANNEL-1-MAP_PARAM_FAILURE: mapping parameter failed for
Parameter mapping failed.
Explanation
Recommended Action Specified service has failed; check its status.
ETH_PORT_CHANNEL-1-MCAST_SEND_FAILURE: failed to send multicast
Explanation The system has failed to send a multicast message to all modules, usually because some
module went down.
Recommended Action Run show port channel consistency to check consistency.
Chapter 2 System Messages and Recovery Procedures
OL-15994-03