Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 28

Cisco mds 9000 family release notes for cisco mds san-os release 3.1(3) (ol-12208-05, may 2007)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Table 9
DDTS Number
CSCsg19148
CSCsg19303
CSCsh21262
CSCsh75149
CSCsi27133
CSCsi33396
CSCsi41668
CSCsi51436
Severity 4
CSCsh68830
CSCsi47053
CSCsi52049
Severity 6
CSCsi29922
CSCsi29932
1. This issue was resolved in Cisco Fabric Manager Release 3.1(2c). For additional information, refer to the
Resolved Caveats
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.1(3)
28
Open Caveats and Resolved Caveats Reference (continued)
Cisco MDS 9000 Family Fabric Manager Release 3.1(2c).
CSCsh98705
Symptom: As a consequence of possible spanning-tree errors, the Cisco MDS 9124 Switch, the
Cisco Fabric Switch for HP c-Class BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter
stop responding to Telnet and ping commands on the management Ethernet port.
Workaround: This issue is resolved.
CSCsi31860
Symptom: If there is an interruption to the upgrade process on a given module during an upgrade
to Cisco MDS SAN-OS Release 3.1(2), the install all command will fail. This may result in a
condition where some modules and supervisors are running SAN-OS 3.1(2) and the remainder of
modules in the chassis are running an older version of SAN-OS. You may not be able to execute the
install all command again to upgrade the remaining modules to SAN-OS 3.1(2).
If you issue the show install all status command, you may see the following types of messages in
the install logs:
Module X: Upgrading Bios/loader/bootrom.
Warning: please do not remove or power off the module at this time.
-- FAIL. Return code 0x40710001 (BIOS versions are identical).
CAUTION: The BIOS/loader/bootrom of above module may be in corrupted state. Please
try programming it again and DO NOT reboot without programming it successfully,
otherwise you have to manually take out the flash from the card and program it in a
BIOS programming station.
Software Release (Open or Resolved)
3.1(2b)
O
O
O
O
O
O
O
O
O
O
O
O
O
3.1(3)
O
O
1
R
R
R
1
R
R
O
O
R
R
R
R
Release Notes for
OL-12208-05

Advertisement

Table of Contents
loading

Table of Contents