Reconfiguring Ssm Ports Before Upgrading To San-Os Release 3.1(3) - Cisco AJ732A - MDS 9134 Fabric Switch Release Note

Upgrading Your Cisco MDS SAN-OS Software Image
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Issue the no ivr virtual-fcdomain-add vsan-ranges vsan-range command to disable RDI mode on all
Step 2
IVR enabled switches. The range of values for a VSAN ID is 1 to 4093. This can cause traffic disruption.
Note
Check the syslogs for any ISL that was isolated.
Step 3
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED:
%$VSAN 2005%$ Isolation of interface
port-channel 52 (reason: unknown failure)
2005 Aug 31 21:52:04 switch %FCDOMAIN-2-EPORT_ISOLATED: %$VSAN 2005%$
Isolation of interface port-channel 51
(reason: domain ID assignment failure)
Step 4 Issue the following commands for the isolated switches in Step 3:
switch(config)# vsan database
switch(config-vsan-db)# vsan vsan-id suspend
switch(config-vsan-db)# no vsan vsan-id suspend
Step 5 Issue the ivr refresh command to perform an IVR refresh on all the IVR enabled switches.
Issue the copy running-config startup-config command to save the RDI mode in the startup
Step 6
configuration on all of the switches.
Step 7 Follow the normal upgrade guidelines for Release 2.1(2b). If you are adding new switches running Cisco
MDS SAN-OS Release 2.1(2b) or later, upgrade all of your existing switches to Cisco SAN-OS Release
2.1(2b) as described in this workaround. Then follow the normal upgrade guidelines for Release 3.1(3).
Note

Reconfiguring SSM Ports Before Upgrading to SAN-OS Release 3.1(3)

Starting with Cisco MDS SAN-OS Release 3.0(1), the SSM front panel ports can no longer be configured
in auto mode, which is the default for releases prior to Release 3.0(1).
To avoid any traffic disruption, modify the configuration of the SSM ports as described below, before
Note
upgrading a SAN-OS software image prior to Release 3.1(3).
For more information on upgrading SAN-OS software, see the
Software Image" section on page
If the configuration is not updated before the upgrade, the installation process for the new image will
automatically convert all ports configured in auto mode to Fx mode. This change in mode might cause
a disruption if the port is currently operating in E mode.
To upgrade the image on your SSM without any traffic disruption, follow these steps:
Verify the operational mode for each port on the SSM using the show interface command:
Step 1
switch# show interface fc 2/1 - 32
fc2/1 is up
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.1(3)
14
Complete Step 2 for all IVR enabled switches before moving to Step 3.
RDI mode should not be disabled for VSANs running in interop mode 2 or interop mode 3.
9.
"Upgrading Your Cisco MDS SAN-OS
OL-12208-05