Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 80

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
In the following procedure, the existing VSAN has a switch C-186 with a domain ID of 209. In Fabric
Manager, the VSAN is statically configured and a persistent FC ID is enabled. This procedure does not
alter the running domain ID.
To configure a static domain ID for an existing VSAN and enable a persistent FC ID for the same VSAN
using Fabric Manager, follow these steps:
Step 1 In the Logical Domains pane, expand the VSAN to be modified and then choose Domain Manager. See
Figure
Click the Configuration tab.
Step 2
Step 3 Enter the domain ID that is in the Running DomainID (in
Domain Id field.
Change the Config Domain IdType field to static.
Step 4
Click the green Apply Changes... icon
Step 5
Figure C-1
Click the Persistent Setup tab.
Step 6
Step 7 Check the Enable check box.
Step 8 Click Apply Changes.
At this point, the domain ID has been statically set and FC IDs will remain persistent across reboots for
VSAN 3000 on the switch C-186. The persistent FC ID database can be viewed in the Persistent Fcids
tab.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
C-2
C-1.
Enabling Static Domain ID
Appendix C Configuring Static Domain IDs and Persistent FC IDs
Figure C-1, it is 209) field in the Config
.
OL-7765-06