About Rscn Information; Displaying Rscn Information; About The Multi-Pid Option - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 41 Managing FLOGI, Name Server, FDMI, and RSCN Databases
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
•
•

About RSCN Information

A switch RSCN (SW-RSCN) is sent to registered hosts and to all reachable switches in the fabric.
Note The switch sends an RSCN to notify registered nodes that a change has occurred. It is up to the nodes to
query the name server again to obtain the new information. The details of the changed information are
not delivered by the switch in the RSCN sent to the nodes.

Displaying RSCN Information

The following example shows how to display registered device information:
switch# show rscn scr-table vsan 1
The SCR table is not configurable. It is populated when hosts send SCR frames with RSCN information.
Note
If hosts do not receive RSCN information, then the show rscn scr-table command will not return entries.

About the multi-pid Option

If the RSCN multi-pid option is enabled, then RSCNs generated to the registered Nx ports may contain
more than one affected port IDs. In this case, zoning rules are applied before putting the multiple affected
port IDs together in a single RSCN. By enabling this option, you can reduce the number of RSCNs. For
example, you have two disks (D1, D2) and a host (H) connected to switch 1. Host H is registered to
receive RSCNs. D1, D2, and H belong to the same zone. If disks D1 and D2 are online at the same time,
one of the following actions applies:
•
•
Note Some Nx ports may not support multi-pid RSCN payloads. If so, disable the RSCN multi-pid option.
OL-16597-01
Suppressing Domain Format SW-RSCNs, page 41-6
Clearing RSCN Statistics, page 41-6
Configuring the RSCN Timer, page 41-7
Verifying the RSCN Timer Configuration, page 41-7
RSCN Timer Configuration Distribution, page 41-8
The multi-pid option is disabled on switch 1— Two RSCNs are generated to host H: one for the
disk D1 and another for disk D2.
The multi-pid option is enabled on switch 1—A single RSCN is generated to host H, and the RSCN
payload lists the affected port IDs (in this case, both D1 and D2).
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
RSCN
41-5