Registering The Target Device With The Camera - Canon PowerShot SD430 Digital ELPH Wireless Settings Manual

Registering the Target Device with the Camera

Attach the camera to the computer using the interface cable and register the target device
(computer to be connected wirelessly) with the camera. Register the target device using the
Camera Wireless Setup program (a wireless configuration utility). This step is only required the
first time you register a target device.
Before you register the target device, update the camera firmware (software
inside the camera) to the latest version. Download the firmware upgrade
from the same website you downloaded this guide from. Also refer to the
website for instructions on updating the camera's firmware.
• The camera cannot connect wirelessly to computers that have not been
registered as target devices.
• The camera can register up to 7 devices.
A
Wireless Network Already in Use
B
1:1 Direct Connection between Camera and Computer
For Step 9 onward go to
Connection between Camera and Computer (p. 14).
1
A If your wireless network is already in use, confirm that the computer and router are
correctly connected and that the router's wireless settings are correctly configured.
B If there is a 1:1 direct connection between the camera and computer, confirm
that the computer's wireless networking function is working.
2
Attach the supplied interface cable to the
computer's USB port and the camera's
DIGITAL terminal.
3
Turn on the camera and set it to the playback
mode.
The camera's
blue. It will not light up if the memory card in the
camera does not contain any images.
A
Wireless Network Already in Use (p. 12) or
(Print/Share) button will light
B
Power Button
9
1:1 Direct
Playback
Mode