Wsw21; Wsw22 - Brother IntelliFax-3550 Service Manual

Selector
No.
1
Max. waiting time for voice signal
|
5
6
Two-way recording
7
Erasure of message stored in
8 the memory after the message
transfer
Selectors 1 through 5:
In the TAD mode, the equipment waits for voice signal for the time length specified by these
selectors before it automatically shifts to the facsimile message receive mode or disconnects
the line.
If the external TAD is connected to the equipment, the total length of the maximum waiting
time specified by these selectors and the delay time specified by WSW25 (selectors 1 and 2)
should not exceed 40 seconds.
Selectors 6 and 7: Two-way recording (For those models equipped with a built-in TAD)
These selectors select the specifications of the two-way recording feature.
Selector 8: Erasure of message (For those models equipped with a built-in TAD)
Setting this selector to "0" will erase the message recorded in the memory after the docu-
ment retrieval feature transfers the message.
Selector
No.
1
Not used.
|
4
5
Acceptable TCF bit error rate (%)
|
(Only at 4800 bps)
8
Selectors 5 through 8:
Setting two or more selectors to "1" produces addition of percent assigned to each selector.
If you set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.

WSW21

(TAD setting 1)
Function
Max. waiting time for voice signal

WSW22

(Communications setting 1)
Function
Acceptable TCF bit error rate (%)
V – 34
Setting and Specifications
No. 1 2 3 4 5
0 0 0 0 0 : No detection
0 0 0 0 1 : 1 sec.
0 0 0 1 0 : 2 sec.
0 0 0 1 1 : 3 sec.
|
0 1 0 0 0 : 8 sec.
|
1 1 1 1 1 : 31 sec.
No. 6 7
0 0 : A (for U.S.A.)
0 1 : B (Except for U.S.A.)
1 0 : C (without beep)
1 1 : D (OFF)
0: YES 1: NO
Setting and Specifications
0: 0% 1: 8 %
0: 0% 1: 4 %
0: 0% 1: 2 %
0: 0% 1: 1 %
|
|