NETGEAR WNDR3400v2 Installation Manual

Installation Guide
N600 Wireless Dual Band Router
WNDR3400v2
Package Contents:
Ethernet cable
Router stand
(two pieces)
N600 Wireless Router
Power adapter
(with stand attached)
Attach the STAND to the ROUTER:
1. Position the router so that the Power
button is at the bottom and the USB
port is at the top.
2. Snap each piece of the stand onto a
bottom corner of the router.
Step 1:
Unplug the power
to turn off your MODEM.
DSL
or Cable
Internet
Modem
Step 4:
Connect the power adapter to the
ROUTER, then plug it into an outlet.
Wait for the 2.4 GHz LED ( )
2.4
GHz
to turn on.
If none of the LEDs turn on, make sure the
Power On/Off button is in the ON position
(pushed in).
Step 2:
Connect one end of the yellow
Ethernet cable ( ) to your MODEM, and
and the other end to the Internet port
on your ROUTER.
(not included)
Power On/Off
N600 Wireless Router
Step 5:
Connect your computer
to the ROUTER ( ).
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using
the preset wireless security settings
located on the bottom label.
Step 3:
Plug in, then turn on your MODEM.
Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Laptop or Desktop
Computer
Step 6:
Open a browser
If the web page doesn't display
close and re-open the browser to
http://routerlogin.net in the
address bar, or check the
"Tr oubleshooting" section on
the back of this installation guide.