Management - Draytek VigorPro 5500 Series User Manual

3 . 1 6 . 6 M a n a g
3 . 1 6 . 6 M a n a g
This page allows you to manage the settings for access control, access list, port setup, and
SNMP setup. For example, as to management access control, the port number is used to
send/receive SIP message for building a session. The default value is 5060 and this must
match with the peer Registrar when making VoIP calls.
Enable remote firmware
upgrade
Allow management from
the Internet
Disable PING from the
Internet
Access List
Default Ports
User Defined Ports
Enable SNMP Agent
Get Community
Set Community
VigorPro5500 Series User's Guide
e m e n t
e m e n t
Chick the checkbox to allow remote firmware upgrade through
FTP (File Transfer Protocol).
Enable the checkbox to allow system administrators to login
from the Internet. By default, it is not allowed.
Check the checkbox to reject all PING packets from the
Internet. For security issue, this function is enabled by default.
You could specify that the system administrator can only
login from a specific host or network defined in the list. A
maximum of three IPs/subnet masks is allowed.
List IP - Indicate an IP address allowed to login to the router.
Subnet Mask - Represent a subnet mask allowed to login to
the router.
Check to use standard port numbers for the Telnet and HTTP
servers.
Check to specify user-defined port numbers for the Telnet and
HTTP servers.
Check it to enable this function.
Set the name for getting community by typing a proper
character. The default setting is public.
Set community by typing a proper name. The default setting is
private.
157