C6Kenv Messages; C6Kenv-2 - Cisco III - Supervisor Engine III Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message %C6K_WAN_C2W-4-WRITEERROR: C2Wire write failed reg [hex] on device
[chars]

C6KENV Messages

This section contains Catalyst 6500 series switch and Cisco 7600 series router environmental
(C6KENV) messages.

C6KENV-2

Error Message %C6KENV-2-BADFLOWCTRL: Module [dec] not at an appropriate hardware
revision level to support DFC. Power denied
OL-11469-02
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
The SMbus driver failed to write to the specified C2W device.
Explanation
No action is required if this warning message appears occasionally. If the
Recommended Action
message appears often in a short period of time, copy the message exactly as it appears on the
console or in the system log. Research and attempt to resolve the issue using the tools and utilities
provided at http://www.cisco.com/tac. With some messages, these tools and utilities will supply
clarifying information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
The fabric-capable module in the specified slot is not at an appropriate hardware
Explanation
revision level and cannot support a DFC. If a DFC is present, the module will not be activated and
remains powered down.
Remove the DFC to enable the module to operate at its current hardware
Recommended Action
revision level. To enable DFC operation, ensure that the module is at an appropriate hardware
revision level.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
C6KENV Messages
2-19