Cwpa-3; Cwrpspa Messages - Cisco III - Supervisor Engine III Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message %CWPA-2-WHICH_INT: Unexpected [chars] interrupt, INT status = [hex]

CWPA-3

Error Message %CWPA-3-DIAGFAIL: Failed to handle diag [chars] [dec]
Error Message %CWPA-3-PROCCREATEFAIL: Failed to create [chars] process

CWRPSPA Messages

This section contains messages for Shared Port Adapters on the Catalyst 6500 Series Switch and Cisco
7600 Series Router WAN Route Processor (CWRPSPA).
OL-11469-02
The module specified in the error message has encountered an unexpected interrupt.
Explanation
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Explanation The module failed to execute a diagnostics command.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
A module failed to create a process that is necessary for proper functioning of the
Explanation
module.
Copy the error message as it appears, and report it to your technical support
Recommended Action
representative. If a statistics export process was not created, check the I/O rate and the bytes that are
getting incremented in the show interface command output for the non-channelized interfaces on
the FlexWAN/Enhanced FlexWAN modules. You can also get the statistics from the show interface
acc command output or the show interface stats command output.
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
CWRPSPA Messages
2-83