Connecting The Console; Connecting The Chassis To Ground; Table 2-7 Css Console Port Default Settings - Cisco CSS5 SSL K9 - Syst. CSS11500 SSL MODULE Hardware Installation Manual

Chapter 2 Cabling and Troubleshooting the CSS

Connecting the Console

Connecting the Chassis to Ground

Warning
78-16421-01
To connect a console to the CSS, attach the console cable (provided in the
accessory kit) to the Console port on the CSS. Your terminal settings must match
the CSS default settings specified in
Table 2-7 CSS Console Port Default Settings
Parameters
Baud
Data Bits
Parity
Stop Bits
Terminal Type
Flow Control
If a communications problem occurs between the CSS and a console, see the
"Troubleshooting the Console Interface"
Connecting the CSS 11503 or CSS 11506 chassis to earth ground is required for
all DC-powered installations, and any AC-powered installation where compliance
with Telcordia (formerly Bellcore) grounding requirements is necessary. Have the
recommended tools and supplies available before you begin this procedure (see
Table 2-8).
Never defeat the ground conductor or operate the equipment in the absence of
a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable
grounding is available.
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Table 2-7.
Default Settings
9600
8
None
1
VT100/ANSI
None
section later in this chapter.
Connecting the Console
2-23