ViewSonic WMA100 - Wireless Media Adapter User Manual page 53

When I connect the WMA100 to my display, if there is no
screen image or the screen image not clear, what should I do?
NOTE: This applies to the Component or DVI/VGA ports only.
After you turn on the WMA100, press the Output button on the Remote
Control. Wait two (2) seconds and if the image is still not clear, press the
Output button again. If the screen image is still not clear, press Output a
third time. The Output button has a total of three (3) settings.
To optimize the screen image, do the following:
1 Select Setup from the Home page, then select System from the Setup
menu.
2 Use the Up/Down Arrow buttons on the Remote Control to select an
image setting from the table to the right, then press OK.
NOTE: For the best screen image, select your display's Preferred Resolution
(see your display's user manual).
Can I connect the two displays to the Wireless Media
Adapter (for example, using the S-Video port for the TV and
the DVI port for a PC monitor?
No. The Wireless Media Adapter currently only supports one connected
display.
What Windows operating systems support myView Media
Manager software?
Windows XP and 2000.
ViewSonic Wireless Media Adapter
Image Settings Image Settings for
(resolutions) for Component Video
DVI / VGA (YPbPr)
640 x 480 480p
800 x 600 720p
1024 x 768 1080i
1280 x 720
1280 x 768
1280 x 1024 S-Video/Composite
852 x 480 NTSC
(Composite = CVBS)
1366 x 768
46