Verifying Firmware Version Information - Cisco IP CONFERENCE STATION 7936 Administration Manual

Chapter 3 Configuring the Cisco IP Conference Station 7936
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9

Verifying Firmware Version Information

Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
OL-4746-01
Press the Select button.
Enter the administrator password. (The default administrator password is **#.)
Press the Enter softkey.
Press the Up or Down scroll button to select HTTP Port Change, and then press
the Select button.
In the HTTP Port field, enter a new HTTP port number.
The default value is 80. You can enter any number. Users will have to use
Note
this number suffixed to the IP address of the IP Conference Station when
they access the web interface.
Press the Save softkey to save your changes.
Restart the IP Conference Station.
You can obtain information about the firmware version installed on the
IP Conference Station.
Follow these steps to verify the firmware version on an IP Conference Station:
Press the Menu button.
Press the Up or Down scroll button to select the Admin Setup menu.
Press the Select button.
Enter the administrator password. (The default administrator password is **#.)
Press the Enter softkey.
Press the Up or Down scroll button to select System Information.
Press the Select button.

Verifying Firmware Version Information

Cisco IP Conference Station 7936 Administration Guide
3-15