NETGEAR AXM763 - ProSafe 10 Gigabit LRM Installation Manual

Installation Guide
ProSafe 10 Gigabit Base-LRM SFP+ Module AXM763
e
Install Your Optical Module
The 10G Base-LRM SFP+ module provides a full-duplex 10G bps each direction for
Ethernet operation on NETGEAR managed switches.
The switch will automatically detect the AXM763, so you can simply plug it into an
available module slot.
The module can be inserted or removed while the switch is operational.
AXM763
Installing a AXM763 Module
Insert the module firmly into the slot that supports the SFP+ interface. Make sure the
optical cable you use is multi-mode LC to LC duplex cable.
Removing a AXM763 Module
Release the module latch by pulling down the handle bar across the module, and pull
the module out of the module slot.
Table 1:
Technical Specifications
Standards IEEE 802.3aq 10GBase-LRM
Wavelength 1310nm
Dimensions (HxWxD) 0.46" x 0.53" x 2.19"
(11.9 mm x 13.7 mm x 55.7 mm)
Weight 0.018kg
Operating Temperature 23 -158º F (-5 - 70ºC)
Storage Temperature -40 -185 ºF (-40 - 85ºC)
Operative relative humidity 85% @ (25ºC)
Operating Distance Up to 220m for the following multi-mode optical fiber
(MMF):
62.5/125µm (OM1) multi-mode fiber,
50/125µm (OM2) multi-mode fiber,
50/125µm (OM3) multi-mode fiber 'laser optimized'
Connectors LC
Power Consumption <1.5w
MTBF 966,837 hr(110 years)
Safety Certification UL 1950 CSA 22.2 No. 950
Environmental Compliance RoHS