Programming Rnet Controller - Russound ST2 Installation Manual

ST2 TUNER PROGRAMMING

PROGRAMMING RNET CONTROLLER

To Program an RNET controller to operate with the ST2 Tuner:
(refer to the controller's Instruction Manual for details)
1. Enter the Setup Menu by pressing the Setup button on the side of the UNO-S2 keypad.
2. SOURCE SETUP will appear. If programming a CAM6.6, press the Next button once for Source
Setup. Enter the Source Setup Menu by pressing the Play button on the UNO-S2 keypad.
3. BASIC SETUP will appear. Enter the Basic Setup Menu by pressing the Play button again.
4. SOURCE NUM will appear. Use + and - buttons to select the source number to which Tuner 1 is
connected. Press the Play button to enter your choice.
5. SOURCE NAME will appear. Use + and - buttons to select the name for the source (e.g., Tuner 1).
Press the Play button to enter your choice.
6. COMMAND TYPE will appear. Select PERIPHERAL from the list. Press the Play button to enter this
choice.
7. SAVE CHANGES? appears. Select "Yes" and press the Play button to save changes.
8. SOURCE NUM appears again. Repeat steps 4 through 7 to configure the second tuner.
9. Press the Setup button three times to back out of the Installation Menu.
Source Configuration Note:
When the ST2 Tuner is used with the CAV6.6 or other RNET controller, it is configured as an RNET
command type PERIPHERAL and is connected via the RNET bus. This makes the tuner behave as a
fully integrated device with UNO keypad support. Each tuner must be set up with a unique source
number (1 - 6) or unassigned. An unassigned tuner is not controlled by the RNET bus.
Key Function Note: When using the tuner with the CAV6.6 or other RNET system, do not reassign
keypad and remote buttons for tuner control in the controller Key Configuration Menu. When the tuner
is assigned the PERIPHERAL command type in the controller Setup Menu, key assignments and func-
tions are automatically assigned and will operate as shown in the preceding UNO-S2 keypad and
SRC2 remote control diagrams.
25