St2 Tuner Programming; St2 Chassis Setup Menu; Source Number; Update Firmware - Russound ST2 Installation Manual

ST2 Tuner Setup Menus
Note: The Setup Menu procedures must be performed from the ST2 Tuner front panel.
The ST2 Tuner Setup Menus provide setup and naming procedures for the ST2 main chassis, and
each AM/FM tuner module. These procedures include source number assignments, assigning a cus-
tom name to a memory preset or a bank, choosing a region for AM/FM operation (US or Euro), facto-
ry initialization and system information.
If the ST2 is used with a non-RNET system, the ST2 can be connected and operated without any
setup programming. Follow the setup menus if custom names are desired, or for system information.
If the ST2 is used with an RNET system such as CAV6.6, the following minimum setup must be per-
formed for the ST2 to be properly controlled by the RNET controller.
1. ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2. RNET Controller Source Setup Menu - Configure the source numbers assigned in step 1 for Tuners
1 and 2, and assign command type PERIPHERAL.
NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to
the RNET controller (must be powered on last) to establish a connection.

ST2 Chassis Setup Menu

Source Number (Chassis)
The Source Number procedure permits Tuner 1
and Tuner 2 to be assigned the proper source
numbers to be used in an RNET system.
Note: The source number must be assigned as
PERIPHERAL in the RNET controllers.
Note: Each of the ST2 modules can be config-
ured as source number "unassigned" if the mod-
ule is used in another system (e.g., home the-
ater) or will not be used as a source in the RNET
system.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until SOURCE NUM appears on the tuner.
3. Press BAND. TUNER # appears.
4. Press the Tune Up/Down buttons to select the
Tuner #.

ST2 TUNER PROGRAMMING

ST2 TUNER SETUP MENU
5. Press BAND. SOURCE NUM appears.
6. Press the Tune Up/Down buttons to scroll
through the source numbers 1-6.
7. Press BAND to select the source number.
8. Repeat the process for the next tuner.
9. Press TNR SEL to exit the Source Number
menu.
Update Firmware (Chassis)
The Update Firmware procedure allows the ST2
tuner's OS firmware to be updated. The proce-
dure is performed using a DB9 serial cable with
one end connected to the RS-232 port on the
back of the tuner and the other connected to a
PC or laptop. If an OS firmware update is avail-
able, it can be obtained through the Document
Center at www.russound.com .
(continued)
21