Security System Operation (cont'd)
How to Send Emergency Messages
An emergency message for panic or fire can be sent to the central monitoring station
from the Emergency screen. The Emergency screen can be accessed by activating
the "emergency" icon located in the lower-right hand corner of the displayed screen
(see next page for a typical screen).
1. The Emergency screen cannot be accessed while running a diagnostic test or the touch
screen calibration. The Emergency screen also cannot be accessed if the user is in an
Internet session.
2. In some instances a pop-up window may be partially covering the "emergency" icon. If this is
the case, you should first close the pop-up window by pressing either the Done or Cancel
button, whichever may be appropriate, on the pop-up screen.
Once the Emergency screen is accessed, perform the following to send an
emergency message.
26
SCREEN
"EMERGENCY"
ACTION
On the Emergency screen press and hold (for
at least 2 seconds) the associated alarm
button for the type of emergency message you
want to send (Panic or Fire). When the
message is sent, the associated "Message
Sent" statement is displayed in the text box to
the right of the buttons. You are immediately
returned to the screen from which you pressed
the "Emergency" icon.
ICON
AUI-022-V2