Router Front Panel - NETGEAR MBR1200 User Manual

Mobile Broadband 11n Wireless Router MBR1000 User Manual

Router Front Panel

The router front panel shown in the following figure contains control buttons and status LEDs.
Figure 1.
You can use the LEDs to verify status and connections. The following table lists and
describes each LED and button on the front panel of the router.
Table 1. Front Panel Button and LED Descriptions
Button/LED Activity
WPS Press this button to open a 2-minute window for the router to connect with other WPS-enabled
devices. For more information about using the WPS method to implement security, see
Push 'N' Connect (WPS) to Configure Your Wireless Network
Wi-Fi Turn the mobile broadband and Wi-Fi radios in the router on and off. Use the GUI to select
whether the mobile broadband radio or the Wi-Fi radio or both radios will be controlled by this
button. The default is the Wi-Fi radio only. Both radios are on by default.
Power Solid green
Solid amber
Off
Restore Factory Settings
button
WPS
Mobile Broadband/Wi-Fi On/Off
Power
Internet
Wi-Fi
LAN
Ethernet WAN
2G/3G
Signal Quality
Description
The router is powered on and operating normally.
POST (power-on self-test) in progress.
Power is not supplied to the router.
Press the reset button for 6 seconds. The Power LED lights briefly.
When the button is released, the LED blinks red three times and
then turns green as the router resets to the factory defaults.
Chapter 1: Connecting to the Internet
Using
on page 31.
| 7