Bottom Panel - D-Link DCS-1000W Manual

Slide Switch
The slide switch permit user's to determine the type of network
communication media for the DCS-1000W and is positioned on the rear panel.
The three settings are as follows:
LAN (Local Area Network Only)
LAN/WLAN (Local Area Network and Wireless Local Area Network.
Both can be accessed at the same time.)
WLAN (Wireless Local Area Network Only)
I/O Connector
There are four I/O connectors, two for input and two for output situated on the
rear panel. The I/O connectors provide the physical interface to send and
receive digital signals to a variety of external alarm devices. Please refer to
the User's Guide appendix for detailed information.
Antenna Connector
There are two SMA type antenna connectors located at the rear panel of the
DCS-1000W providing connection for two high sensitivity antenna included
with the device.

Bottom Panel

Bracket Cavity
Located on the bottom panel of DCS-1000W the bracket cavity is used to
connect the camera stand onto DCS-1000W by attaching the screw head on
the camera stand into the mounting cavity of DCS-1000W.
Bracket Cavity
8