Checking Battery Power - Honeywell 9900LUP-6211G0 - Hand Held Products Dolphin 9900 User Manual

There are two DWORD values in this registry entry: LowBatt and CriticalBatt.
The default values for these entries are as follows:
LowBatt=19 (25%)
This sets the Low Battery point to 25% (19 hex=25 decimal). When the battery hits the
percentage charge specified here, the user is notified by this icon in the Navigation bar
If the main battery is low and the terminal is in suspend mode, pressing the SCAN or Power
button won't wake the Dolphin terminal; you must replace the discharged battery with a battery
charged over 25% mark before you can resume terminal operation.
CriticalBatt=a (10%)
This sets the Critical Battery point to 10% (a hex= 0 decimal). When the battery hits the
percentage charge specified here, the user is notified by this icon in the Navigation bar
Note: Warnings do not appear when the terminal is on external power.
Setting Critical and Low Battery Points
Developers can reset these parameters in the registry from 0 (no warning) to 99 (would nearly always
warn). You can review and set these battery points in the RegEdit Power Tool.
1. Tap Start > Power Tools > RegEdit.
2. Drill-down to HKEY_LOCAL_MACHINE > System > CurrentControlSet > Control > Power.
3. Tap the Value Name to change the Value Data.
You can reset the Value Data from 0 (no warning) to 99 (would nearly always warn).
4. Tap OK to save changes.
For more information about the RegEdit Power Tool, refer to the Dolphin Power Tools User's Guide
available for download at www.honeywellaidc.com.

Checking Battery Power

Tap Start > Settings > System tab > Power.
For more information, see Power on page 6-12.
.
.
3 - 17