NETGEAR DGN2200-100NAS User Manual page 33

To set up basic wireless connectivity:
1. Log in to the wireless-N modem router at its default LAN address of http://192.168.0.1 with
its default user name of admin and default password of password, or using whatever LAN
address and password you have set up.
You can also enter either of these addresses to connect to the wireless-N modem
router: http://www.routerlogin.net or http://www.routerlogin.com.
2. Select Add WPS Client (computers that will connect wirelessly to the router are clients) in the
main menu. The Add WPS Client wizard screen displays.
Note: If you cannot select Add WPS Client, check to see if WPS is disabled in the
Advanced Wireless Settings screen. See
3. Click Next. The screen changes to allow you to select the method for adding the WPS client.
4. Select the method for adding the WPS client. A WPS client can be added using the Push
Button method or the PIN method.
• Using the Push Button. This is the preferred method. (See
– Select the Push Button radio button and either press the WPS Push Button on the
front panel of the wireless-N modem router or click the soft WPS Push Button on the
screen (as shown below).
– The wireless-N modem router tries to communicate with the client; you have 2
minutes to enable WPS from the client device using its WPS networking utility.
:
Figure 2-3
Configuring Your Wireless Network and Security Settings
Wireless-N 300 Modem Router DGN2200 User Manual
"Using Static Routes" on page
v1.0, March 2010
Figure 2-3 on page 2-12.)
6-15.
2-12