Casio YW-2L - Wireless LAN For Projector Connecting Manual page 43

Setting Name Description
Subnet Mask Configuration of this setting is required when "Off" is selected for "DHCP".
Enter a subnet mask value, which specifies the range of the IP address of
the subnet to which the Data Projector/computer belongs. The subnet mask
consists of four values in the range of 0 to 255, separated by periods (such
as 255.255.255.0).
Default Configuration of this setting is required when "Off" is selected for "DHCP".
Gateway When "Access Point" is selected for "Access Mode", specify the same value
as the wireless LAN access point.
Channel Configuration of this setting is required when "Ad Hoc" is selected for
"Access Mode". When there is a large number of devices performing wireless
LAN communication using frequencies in the same frequency band (2.4 GHz)
used by the Data Projector, you can improve communication performance by
assigning different channels to each wireless LAN network. Normally you
should leave this item set to "Auto" (initial default setting).
Auto*:
Automatically assigns a communication channel for wireless LAN
communication. If "Auto" is selected on the Data Projector, also select
"Auto" for the computer as well.
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11:
Specify a channel that should be used for wireless LAN communication.
The same channel must be set on the Data Projector and the computer
that will be communicating with each other over the wireless LAN
connection.
43