Table of Contents
Advertisement
Using a Manual Connection Profile for Wireless LAN
Connection between the Data Projector and One or
More Computers
First Wireless LAN Connection between the Data
Projector and Four Computers
The following procedure uses the initial default settings of the Manual Connection 1
connection profile to establish wireless LAN connections between the Data Projector and
four computers for the first time.
Important!
The XJ-S35/YP-100 does not have manual connection initial values registered. Before
performing the following procedure, use the procedure under "Sending Settings from a
Computer to the Data Projector" (page 34) to send Manual Connection 1 profile
settings from your computer to the projector.
You should use Wireless Connection 2 on all of the computers connecting to the
Data Projector. Do not use an older version of Wireless Connection.
To change the Data Projector connection profile to Manual Connection 1
1
Turn on the Data Projector and connect the CASIO YW-2 wireless adapter to the
Data Projector's USB port.
This will start up Wireless automatically and display the "Standing by for connection..."
message on the projection screen.
2
On the Data Projector's remote controller, press the [ ] key.
This will cause the connection profile menu to appear in the projection area.
3
Press the [ ] key three times to move the highlighting to "Manual Connection
1" and then press the [ENTER] key.
This will display a connection profile change confirmation dialog box.
4
Press the [ ] key to move the highlighting to "Yes" and then press the [ENTER]
key.
This will close the confirmation dialog box and return to the "Standing by for
connection..." message.
Next, perform the procedure under "To establish a wireless LAN connection with Manual
Connection 1 between the first computer and the Data Projector" below.
11
Advertisement
Table of Contents
